User Manual

320
────────────────────────────────────────────────────
12.5 INTERFACE Screen (SYSTEM 4)
────────────────────────────────────────────────────
：Output color data
：Output gray-scale data
Selection
Selection
：Output monochrome data
：Output reverse monochrome data
NOTE
1
2.5.2 Output Destination by the PRINT key
Selection
Selection
：Uses ESC/P as the control code
：Uses ESC/P raster as the control code
Selection
Selection
：Output color data
：Output monochrome data
Selection
Selection
NOTE
When the internal printer is not the output destination, select the color of the
output destination.
When floppy disk, PC card, interface, SCSI, or MO drive is selected as the
output destination, specify a file name for saving data in BMP format.
・When the output destination specified excluding internal and external
printer and the color is set to monochrome, the screen is displayed in
monochrome while data saving is in progress.
・Stores a file in the directory currently selected on the file screen. See
Section 14.12.2.
・Refer to the printer operating manual for the control codes.
・Files stored in BMP format cannot be read by the 8826.
The measurement data output destination when the PRINT key is pressed is
specified.
When the external printer is the output destination, select the control code.
When the external printer is the output destination, select the color of the
output destination.
・Even if the information that has been input using the PRINT key is to be
output to the external printer, automatic printing or real-time printing is
performed on the internal printer rather than the external printer.
・Refer to the printer operating manual for the control codes.