User Manual

313

────────────────────────────────────────────────────

12.2 SET UP Screen (SYSTEM 1)

────────────────────────────────────────────────────

2.2.2 Start Backup

：The start key backup function is not used.

：The start key backup function is used.

Selection

2.2.3 Back Light Saver

：Increase time (1 to 30).

The display automatically goes off after the preset

interval (minutes).

：Decrease time (1 to 30).

Selection

：The display is shown continuously.

2.2.4 Display Color

：Display color number up

：Display color number down

Selection

：Make the customer color.

・When this function is enabled, the unit will operate as follows: If the power

supply is interrupted during recording operation (while the START key LED is

lit), and then the power supply is restored, the 8826 goes back into the

measurement operation mode, and recording is restarted immediately.

・If the trigger function is used, the unit goes into trigger standby mode.

However, this is disabled with the timer trigger.

・When this function is enabled, LCD back lighting is turned off automatically if

no key is pressed for the preset interval.

・Pressing any key will turn the display on again.

・This increases the service life of the back light.

・Serves to set the display color.

・The display color can be selected from among the display colors 1 to 8 and

the customer color 9 which can be set as desired.