User Manual

309

────────────────────────────────────────────────────

11.6 View Function (VIEW key)

────────────────────────────────────────────────────

Screen: DISPLAY

Press the VIEW key on the display screen

shows at the bottom of the screen the

position with respect to the recording

length of the displayed part of the

waveform.

Using the function key to select "block

display".

Method

：Shifts the destination to the left.

：Shifts the destination to the right.

Selection

：Toggles block display.

：Toggles position display.

In the case of 127 or 255 divisions, select a

bar graph using the up and down cursor

keys.

Use the function keys to move the "^"

mark and specify the memory block you

wish to display.

Using the function key to select the "exec"

NOTE

Block display (MEM only)

・When memory segmentation is being used, the memory block status is

shown.

・Sequential save and multi-block function can be used block display.

・Any block in which an input signal is recorded can be called up on the

display.

・Memory segmentation can be carried out with the memory recorder

function.

・While the view function is active, the flashing cursor is not displayed and

the settings cannot be changed.