User Manual

308
────────────────────────────────────────────────────
11.6 View Function (VIEW key)
────────────────────────────────────────────────────
Screen: DISPLAY
Press the VIEW key on the display screen
shows at the bottom of the screen the
position with respect to the recording
length of the displayed part of the
waveform.
Move the ( ) mark to the desired point
with function key.
Method
Method
：Shifts the destination to the left.
：Shifts the destination to the right.
Selection
Selection
：Executes the dislocation.
：Toggles block display.
Using the function key to select "exec".
high-speed shift is carried out and the
display position changes.
0%
25%
50%
75%
T（Trigger） A（Cursor）
100%
Time from trigger point（MEM, RMS, REC&MEM）
Time from measurement start
（
REC, REC&MEM）
NOTE
・While the view function is active, the flashing cursor is not displayed and
the settings cannot be changed.
・Even during measurement, the position of the waveform can be displayed by
pressing the VIEW key.
・If the recording length is equal to or less than four times the width of the
waveform display screen, the dislocation function is not enabled.
・When the recording length is set to "CONT" on the recorder or RMS
recorder and at least 2000 divisions (10,000 divisions for 64 M words) are
recorded, the time displayed does not represent the value counted from the
trigger point (Recorder function: recording start point).
・When the recording length of recorder waveform in REC&MEM is set to
"CONT." and at least 1000 divisions (5000 divisions for 64 M words) are
recorded, the time displayed does not represent the value counted from the
recording start point.
・In the FFT function, view function cannot be carried out.