User Manual

299
────────────────────────────────────────────────────
11.2 Using the A/B Cursors
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
NOTE
・When the A･B CSR SELECT key is used to activate the A/B cursor mode,
the trace cursor (X-Y CONT: line cursor) can be used, also if it was set to
OFF.
・Only channels for which a waveform is being displayed can be specified.
・By specifying a different channel for the A and B cursors, a potential
difference between the waveforms in the respective channels can be
determined.