User Manual

297

────────────────────────────────────────────────────

11.2 Using the A/B Cursors

────────────────────────────────────────────────────

NOTE

・When the A･B CSR SELECT key is used to activate the A/B cursor mode,

the trace cursor (X-Y CONT: line cursor) can be used, also if it was set to

OFF.

・When the vertical cursor or trace cursor is used, cursor measurements are

possible also when one of the cursors is currently off screen. When the

cursor is set to A&B and either the A or B cursor is moved, both A and B

cursors are shifted onto the screen.

・When the vertical cursor or the trace cursor is off screen, the VIEW key can

be used to check the cursor position within the total recording length.

・When the cursor is moved to the edge of the screen, the waveform is

scrolled.

・If turning the the SHUTTLE control fully and holding the control for about

five seconds, the indication Auto scroll appears on the function key display

and the waveform continues to scroll even if releasing the control. Auto-

scroll is canceled by pressing any key.

・In additional recording (REC, RMS, REC&MEM), the junction between data

is invalid data.