User Manual

6
────────────────────────────────────────────────────
1.2 Names and Function of Parts
────────────────────────────────────────────────────
1
2
3
4
6 7 8 9 1
1
1
0
1
2
1
3
1
4
1
5
1
7
5
1
8
1
6
1
Input unit slots
･ These slots accept input units.
2
Analog input connector
･ Unbalanced analog input. (on ANALOG UNIT)
3
Logic probe connectors
･ Input connector for the logic input section, designed for
the dedicate logic probes (CH A to H).
4
KEY LOCK switch
･ When this switch is set to ON, all keys of the 8826 are
inactive. The key lock condition is maintained also when
the power is switched off and on again.
5
Ventilation slots
6
Fastening screw
･ Secures the plug-in unit.
7
AC connector
･ The supplied power cord must be plugged in here.
8
Function ground terminal (GND)
･ Connects to the earth.
9
Trigger terminals
･ Can be used to synchronize multiple units, using the
EXT TRIG input and TRIG OUT output.
10
ground terminal (GND)
･ Uses with
9
,
11
,
12
,
13
,
14
,
15
terminals.
11
External sampling terminal
･ Allows input of an external sampling signal.
12
External print terminal
･ Print operation can be controlled.
13
NG evaluation output
terminal
･ When the waveform evaluation has resulted in NG, a
signal is output from this terminal.
14
GO evaluation output
terminal
･ When the waveform evaluation has resulted in GO, a
signal is output from this terminal.
15
External start/stop
terminals
･ Start and stop operation can be controlled.
16
SCSI connector
･ An MO drive can be connected.
17
Eject button
･ Removes the PC card.
18
PC card slot
･ Inserts the PC card.