User Manual

278

────────────────────────────────────────────────────

10.8 Analog Trigger

────────────────────────────────────────────────────

Move the flashing cursor to the position

shown in the figure.

Use the function keys or the JOG control

to set the trigger level. The rms value as

well as the trigger level are displayed.

：Value up, large step

：Value up, small step

Selection

：Value down, small step

：Value down, large step

(3) Set the trigger level.

Setting Item Setting Method

Trigger mode Function key

Trigger type Function key

Channel Function key, Jog (VALUE select key)

Trigger level Function key, Jog (VALUE select key)

RMS value

Pre-trigger Function key, Jog (VALUE select key)

Restriction：The frequency cannot be set.

The selected window is not displayed in the pre-

trigger setting.

1.000 V

1/2 cycl

Settings on the DISPLAY screen

Example for Voltage Drop Trigger

For a signal such as shown in the illustration (frequency 50 Hz), the following

applies:

V max. < 1.000 V (RMS < 707.1 mV rms)

To perform trigger measurement under the above conditions, make the

following setting.

Voltage drop f = 50 Hz Level = 1.000 V (707.1 mV rms)