User Manual

259
────────────────────────────────────────────────────
9.14 Setting the 8947 CHARGE UNIT
────────────────────────────────────────────────────
9
.14.3 Setting the Voltage Mode
Screen: CHANNEL1, DISPLAY
Call up the CHANNEL1 or DISPLAY
screen.
Use the CH.SET key to display the desired
channel screen.
Use the CURSOR key to move the flashing
cursor to the graph position.
Use the function keys or the JOG control
to set the VOLT.
：Move the arrow up in the selection
window.
：Move the arrow down in the
selection window.
Selection
Selection
Method
Method
Flashing curso
r
(1) Setting the measurement mode
Flashing curso
r
(2) Setting the Anti-aliasing Filter
Selection
Selection
：Anti-aliasing filter is disabled.
：Anti-aliasing filter is enabled.
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys to make selection.
The anti-aliasing filter can only be selected from the
CHANNEL screen.