User Manual

246
────────────────────────────────────────────────────
9.13 Setting the 8940 F/V UNIT
────────────────────────────────────────────────────
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys to make selection.
Selection
Selection
Flashing curso
r
(3) Setting the pull-up resistance
Set the pull-up resistance on or off. Pull-up
resistance is used when connecting to an open
collector output signal. For normal
measurements, disable the pull-up resistance
(set to OFF).
：Pull-up resistance is enabled (ON).
(for connection to open collector
output)
：Pull-up resistance is disabled
(OFF).
Pull-up resistance: OFF
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys to make selection.
Selection
Selection
Flashing curso
r
(4) Setting the threshold value
：Value up, large step
：Value up, small step
：Value down, small step
：Value down, large step