User Manual

232
────────────────────────────────────────────────────
9.10 Setting the 8937 VOLTAGE/TEMP UNIT
────────────────────────────────────────────────────
9
.10.1 Making the Settings of Voltage Measurement
Screen: CHANNEL1, DISPLAY
Call up the CHANNEL1 or DISPLAY
screen.
Use the CH.SET key to display the desired
channel screen.
Use the CURSOR key to move the flashing
cursor to the graph position.
Use the function keys, the JOG control to
select the VOLT.
：Move the arrow up in the selection
window.
：Move the arrow down in the
selection window.
Selection
Selection
Method
Method
Flashing curso
r
(1) Setting the measurement mode
Flashing curso
r
(2) Setting the measurement range
Move the flashing cursor to the position
shown in the figure on the left.
Use the JOG control, the function keys or
the RANGE key to set the measurement
range.
：Move the arrow up in the selection
window.
：Move the arrow down in the
selection window.
Selection
Selection
The digital filter can be configured when the measurement range is 500μVto
2 mV. The digital filter is a function which eliminates the noise component by
additive averaging inside the amplifier. This results in a data update rate of
about 100 μs.