User Manual

222
────────────────────────────────────────────────────
9.8 Comment Function (SYSTEM 3)
────────────────────────────────────────────────────
9
.8.2 Analog Channel Comment Input
Screen: COMMENT (SYSTEM3
)
Press the SYSTEM key to call up the
SYSTEM3 screen.
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys to select the desired
channel screen.
(Press the CH.SET key can change screen.
)
：Analog CH1 to 16: COMMENT
：Analog CH17 to 32: COMMENT
Selection
Selection
Method
Method
：Logic CHA to D: COMMENT
：Logic CHE to H: COMMENT
Flashing curso
r
Move the flashing cursor to the desired
channel.
Use the function keys to make the
selection.
：Standard printout is performed.
：Setting item is printed.
Selection
Selection
：Comment is printed.
：Both item and comment are
printed.
Flashing curso
r
・Analog channel comment input is described.
・Three types of analog channel comment are available.
(1) SET: Full-span voltage for each channel, measurement range,
magnification/compression ratio along the measurement range, zero
position, low-pass filter setting
(2) COMMENT: Comment of up to 40 characters
(3) SET & COMMENT: Both (1) and (2)