User Manual

218
────────────────────────────────────────────────────
9.7 Scaling Function (SYSTEM2)
────────────────────────────────────────────────────
Move the flashing cursor to the desired
item.
Use the function key to select the
TEN-KEY INPUT.
Use the CH&NUM key to enter the
numerical value.
：Clear the currently displayed
comments.
：Performs backspacing.
The value that has been input most
recently will be displayed if the
backspace function is used without
entering new data.
Selection
Selection
Using the CH&NUM ke
y
：Enable the input value and escape
from the ten-key input screen.
Move the flashing cursor to the position
shown in the figure on the left and enter the
required unit. See Section 9.8.4.
CH&NUM key Enter the numerical value
POSITION key Enter the " −", "＋"
RANGE key Enter the ". " ,"E"
Press the CH
ENT
key to fix the entering.
(3) Entering the numerical value
(4) Enter the "Unit name: eu"
Flashing curso
r
NOTE
・Settings made for one channel can be copied to another channel.
See section 9.4.
・When the scaling and waveform processing are simultaneously specified, the
scaling function is not applied to the results of the waveform processing
stored in the internal memory.