User Manual

214
────────────────────────────────────────────────────
9.6 Setting the CHANNEL2 Screen
────────────────────────────────────────────────────
Move the flashing cursor to the desired
channel. Move the flashing cursor to the
lower or upper limit.
Use the function key to select the
TEN-KEY INPUT.
Method
Method-2
：Value u
p
：Value dow
n
Selection
Selection
Using the CH&NUM ke
y
：Reset. The reset value is
determined by the measurement
range, zero position, and
magnification ratio.
：Enter the value using the CH&NUM
keys.
Use the CH&NUM key to enter the
parameter. The unit (eu) sets the
SYSTEM2 (SCALING) screen.
：Clear the currently displayed
comments.
：Performs backspacing.
The value that has been input most
recently will be displayed if the
backspace function is used without
entering new data.
Selection
Selection
：Enable the input value and escape
from the ten-key input screen.
CH&NUM key Enter the numerical value
POSITION key Enter the " −", "＋"
RANGE key Enter the ". " ,"E"
Press the CH
ENT
key to fix the entering.
Screen: CHANNEL
2
Flashing curso
r
NOTE
・When the screen size (normal/wide) is changed, the upper and lower limits
are also changed.
・Variable function and scaling function processing can be carried out
simultaneously.
・Settings made for one channel can be copied to another channel.
See section 9.4.
・Although the variable function cannot be enabled or disabled on the display
screen, the values of the enabled channels can be changed.