User Manual

213
────────────────────────────────────────────────────
9.6 Setting the CHANNEL2 Screen
────────────────────────────────────────────────────
Screen: CHANNEL2, DISPLAY
Call up the CHANNEL2 or DISPLAY
screen.
Use the CH.SET key to display the desired
channel screen.
Use the cursor key to move the flashing
cursor to the desired channel.
Use the function keys to make the
selection.
Method
Method
：Variable function is disabled.
：Variable function is enabled.
Selection
Selection
Move the flashing cursor to the position shown
in the figure on the left, and set the lower and
upper limits.
Move the flashing cursor to the desired
channel.
Move the flashing cursor to the respective
columns and select columns individually
with the JOG control, the function keys or
the CH&NUM key. (Move the column with
the cursor keys.)
The unit (eu) sets the SYSTEM2
(SCALING) screen.
Method
Method-1
：Value up
：Value down
Selection
Selection
Using the function key or the JOG contro
l
：Reset. The reset value is
determined by the measurement
range, zero position, and
magnification ratio.
：Enter the value using the CH&NUM
keys.
Screen: CHANNEL2, DISPLAY
Flashing curso
r
Flashing curso
r