User Manual

207

────────────────────────────────────────────────────

9.4 Copying Channel Settings

────────────────────────────────────────────────────

Screen: CHANNEL1, DISPLAY

Press the CHAN key to call up the

CHANNEL1 screen.

Move the flashing cursor to the number of

the channel to be used as copy target.

Use the function keys or the JOG control

to specify the copy source channel.

Method

：Increase channel number

：Decrease channel number

Selection

Selection of "for ALL" enables the settings

(comments) for the channel with the

flashing cursor to be copied to all channels

When the F5 [ set ] is pressed, the

settings of the copy source channel are

copied to the copy target channel.

For variable function and scaling function,

the settings are copied in an identical.

copy targe

copy sourc

NOTE

.4 Copying Channel Settings

Copies any of input channel settings (voltage axis range, input coupling, and

low-pass filter), variable function settings, scaling function settings, or

comment function settings to another channel.

Copying is not possible if the copy source and destination are different, or if

the measurement mode is different when copying from and to the same unit.

・Magnification and zero position are copied to the desired destination only

when the copy source is set to "for ALL" when copying is performed in the

"input channel settings."

・It is not possible to copy the settings of input channels and variable function

in a single operation.