User Manual

205
────────────────────────────────────────────────────
9.3 Setting the CHANNEL1 Screen
────────────────────────────────────────────────────
9
.3.8 Setting the Logic Inputs
Screen: CHANNEL1, DISPLAY
Call up the CHANNEL1 or
DISPLAYscreen.
Use the CH.SET key to display the logic
channel screen.
Move the flashing cursor to the Position
point of the channel to be set, as shown in
the figure on the left.
Use the function keys to set the position.
Press the F5 [SET] key to change the
display position.
Method
Method
：Change the display position.
：Change the display position.
Selection
Selection
：Logic waveforms are not displayed.
：All logic waveforms are displayed.
：Set to the displayed position
number.
Position
1
4
5
6
7
8
2
3
The logic waveform displa
y
positions are as follows.
When the display format is set to "oct" or
"hex," the display position is automatically
adjusted.
For oct:
The logic waveform set at positions 1
through 8 is printed in graphs 1 through 8.
For hex:
A two-channel logic waveform is printed on
a single graph. (The logic waveform at
position 1 is printed on graphs 1 and 2.)
Flashing curso
r
・Select the display positions for CHA - CHH (1 probe).
・Select the display color for the logic waveform.