User Manual

202
────────────────────────────────────────────────────
9.3 Setting the CHANNEL1 Screen
────────────────────────────────────────────────────
9
.3.6 Setting the Zero Position
Screen: CHANNEL1, DISPLAY
Call up the CHANNEL1 or DISPLAY
screen.
Use the CH.SET key to display the desired
channel screen.
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys, the JOG control or
the POSITION key to make the selection.
：Changes the +10% zero position.
：Changes the +1% zero position.
Selection
Selection
Method
Method
：Changes the -1% zero position.
：Changes the -10% zero position.
Flashing curso
r
NOTE
The position of the zero voltage is set.
・The POSITION key can be used regardless of where the flashing cursor is
located, if the CHANNEL1 or DISPLAY screen is displayed.
・Magnification/compression along the measurement range is performed using
the center of the screen as reference,even if the magnification/compression
ratio is changed.