User Manual

199

────────────────────────────────────────────────────

9.3 Setting the CHANNEL1 Screen

────────────────────────────────────────────────────

.3.3 Setting the Measurement Range

Screen: CHANNEL1, DISPLAY

Call up the CHANNEL1 or DISPLAY

screen.

Use the CH.SET key to display the desired

channel screen.

Move the flashing cursor to the position

shown in the figure on the left.

Use the function keys, the JOG control or

the RANGE key to make the selection.

Method

：Move the arrow up in the selection

window.

：Move the arrow down in the

selection window.

Selection

Flashing curso

NOTE

・The measurement range for each channel is set.

・The set value denotes the voltage value for 1 DIV along the measurement

range (vertically).

・The RANGE key can be used regardless of where the flashing cursor is

located, if the CHANNEL1 or DISPLAY screen is displayed.

・If the variable function is enabled, the size of a waveform on the screen does

not change, even if the measurement range is changed.

・When the waveform is out of range, the color of the displayed waveform on

the screen is changed.

・When using the RMS recorder function, you cannot set the lowest sensitivity

range of each unit (20 V/DIV for the 8936).