User Manual

viii

────────────────────────────────────────────────────

Notes on Use

────────────────────────────────────────────────────

CAUTIO

■ Installation environment

･ This instrument should be installed and operated indoors only, between 5 and

40℃ and 35 to 80% RH.

･ Do not store or use the instrument where it could be exposed to direct

sunlight, high temperature or humidity, or condensation. Under such

conditions, the instrument may be damaged and insulation may deteriorate

so that it no longer meets specifications.

･ To avoid electric shock, do not allow the instrument to get wet, and do not

use it when your hands are wet.

･ Do not use the instrument where it may be exposed to corrosive or

combustible gases. The instrument may be damaged or cause an explosion.

■ Before powering on

･ The microgap power switch construction necessitates that the instrument be

used near a power outlet. When not in use and while making connections to

the circuit to be tested, disconnect the instrument from the power source by

unplugging it from the outlet.

■

Using a connection cable

･ Use only the specified connection cord. Using a non-specified cable may

result in incorrect measurements due to poor connection or other reasons.

■

Storing

･ When the unit is not to be used for an extended period, set the head

up/down lever to the "head up" position. This will protect the printer head

and prevent deformation of the rubber roller.

■ Precautions on carrying this equipment

･ The terminal guard of the equipment protects the inputs. Do not hold this

guard when carrying the equipment. To carry this equipment, use the

handle. See section 1.2.

■

Shipping

･ Remove the printer paper from the unit. If the paper is left in the unit, paper

support parts may be damaged due to vibrations.

･ To avoid damage to the instrument, be sure to remove the floppy disk, MO

disk, PC card, and SCSI cable before shipping.