User Manual

169
────────────────────────────────────────────────────
8.4 STATUS2 Settings (FFT)
────────────────────────────────────────────────────
Move the flashing cursor to type, and select
the format.
：Data are stored as binary data.
：Data are stored as text data.
Data stored in the text format is
not readable by the 8826.
Selection
Selection
Set the file name. For the input method,
refer to Section 9.8.4.
When using auto-save, a number is
appended to the name you specify as the
file name. This then becomes the file
name. If you start procedures before
specifying a file name, AUTO is
automatically enabled.
・ Do not use the characters and symbols
below in a file name. A file containing any
of these characters/symbols in its file nam
e
cannot be processed under Windows 2000
or XP. Half-size symbols: +, =, [,]
NOTE
・When auto-save is enabled, the storage channel cannot be selected. Data for
the channel for which the waveform is displayed is saved.
・For details on auto saving file name, refer to Section 14.7.
・When auto save is used together with the auto print, auto save is carried
out after auto print is completed.
・For details on connected SCSI device, refer to Section 14.4.
・The directory and the number of files that can be stored in the directory are
limited. For details, see Section 14.7.
・Thinning is not applied with FFT data text format storage.
・When "COMMUNI" (communications) is selected as Media, Storage Method and Type
are not displayed.