User Manual

166
────────────────────────────────────────────────────
8.4 STATUS2 Settings (FFT)
────────────────────────────────────────────────────
8
.4.3 Setting the Print Mode
Screen: STATUS
2
Press the STATUS key to call up the
STATUS2 screen.
Move the flashing cursor to the print mode
item, as shown in the figure on the left.
Use the function keys to make the selection
.
：Measurement data and the result o
f
calculation are printed as a
waveform.
：Measurement data and the result o
f
calculation are printed as numeric
data.
Selection
Selection
Method
Method
When the LOGGING data format is
selected, set the print interval.
Move the flashing cursor to the interval
item.
Use the JOG control or the function keys
to select the print interval.
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Selection
Selection
(1) Setting the Printer Format
(2) Setting the print interval
Select the format, waveform, or numerical value should be used to output
measured data and calculation results.