User Manual

160
────────────────────────────────────────────────────
8.4 STATUS2 Settings (FFT)
────────────────────────────────────────────────────
8
.4.1 Setting the Averaging Function
Screen: STATUS
2
Press the STATUS key to call up the
STATUS2 screen.
Move the flashing cursor to the averaging
item, as shown in the figure on the left.
Use the function keys to make the selection
.
Method
Method
Move the flashing cursor to the count
item.
Use the JOG control or the function keys
to set the averaging count.
GUI Mode GUI Mode
Disable averaging
Perform frequency axis waveform
summing averaging
Perform time axis waveform summing
averaging
Perform frequency axis waveform
exponential averaging
Perform time axis waveform
exponential averaging
Frequency axis waveform peak hold
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Selection
Selection
8
.4 STATUS2 Settings (FFT)
・The averaging function allows capturing several instances of a waveform
and determining the average.
・This makes it possible to eliminate noise and irregular signal components.
・The higher the number of averaging instances, the more effectively will
noise be suppressed.