User Manual

154
────────────────────────────────────────────────────
8.3 STATUS1 Settings (FFT)
────────────────────────────────────────────────────
8
.3.8 Setting the FFT Analysis Mode
Screen: STATUS1, DISPLAY
Call up the STATUS1 or DISPLAY screen
.
Move the flashing cursor to the FFT mode
item, shown in the figure on the left.
Use the function keys to make the selection
.
FordetailonFFTmode,seeSection8.7.
Method
Method
GUI Mode GUI Mode
Stored waveform (Section 8.7.1)
Transfer function (Section 8.7.7)
Linear spectrum (Section 8.7.2)
Cross power spectrum (Section 8.7.8)
RMS spectrum (Section 8.7.3)
Cross correlation function (Section 8.7.9)
Power spectrum (Section 8.7.4)
Impulse response (Section 8.7.10)
Auto correlation function (Section8.7.5)
Coherence function (Section 8.7.11)
Histogram (Section 8.7.6)
Octave analysis ( Section 8.7.12)
8
.3.9 Setting the Analysis Channel
Screen: STATUS1, DISPLAY
Call up the STATUS1 or DISPLAY screen
.
Move the flashing cursor to the w1 item,
shown in the figure on the left.
Use the function keys or the JOG control
to select the channel.
Method
Method
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Selection
Selection
Used to select the FFT calculation method.
Select the channel for FFT analysis.