User Manual

151
────────────────────────────────────────────────────
8.3 STATUS1 Settings (FFT)
────────────────────────────────────────────────────
8
.3.6 Setting the Format
Screen: STATUS
1
Press the STATUS key to call up the
STATUS1 screen.
Move the flashing cursor to the format
item, shown in the figure on the left.
Use the function keys to make the selection
.
Method
Method
：Single
：Dual
Selection
Selection
：Nyquist
If SINGLE or DUAL was selected in step ,
the peak item is displayed.
Use the function keys to make the
selection.
：OFF
：Shows the 10 peak values
Selection
Selection
：Shows the 10 highest peaks
Peak value
・When data at one point are higher than
data within the vicinity, the point is a
peak. The 10 highest peaks are shown.
Maximum value
Points with the 10 highest values are shown.
Peak
1
○,●････Data
Peak
2
Maximum value
1
○,●････Data
3
2
4
5
6
・You can set the format for displaying input signal waveforms on the screen
and recording them on the printer.
・The SINGLE, DUAL, and NYQUIST formats are available.