User Manual

145
────────────────────────────────────────────────────
8.2 Operation Sequence (FFT)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
測定を開始します
・Press the START key and the LED lights.
・When the trigger conditions are met, measurement start.
・Press the STOP key and the LED goes out after measurement has
finished.
Printout the measurement data
Save the measurement data
See Section →11.2.
Using the A/B cursor
See Chapter →13.
See Chapter →14.
Starts Measurement
・See Chapter →12.
Setting the SYSTEM Scree
n
Operating the DISPLAY Scree
n
・Set the trigger source, trigger types and conditions, the pre-
trigger, etc.
See Chapter 10.
・Set the waveform display color for each channel,
measurement range, input coupling, zero position, and filter.
See Chapter 9.
Setting the CHANNEL Scree
n
Setting the CHANNEL Scree
n
Setting the TRIGGER Scree
n
Setting the SYSTEM Scree
n
Operating the DISPLAY Scree
n
Printouts and Saves the dat
a
Setting the TRIGGER Scree
n
Printouts and Saves the dat
a
See Section 8.6.