User Manual

144
────────────────────────────────────────────────────
8.2 Operation Sequence (FFT)
────────────────────────────────────────────────────
測定の準備を行います
Installation of the Unit
Turn on the power
Connect the inputs
Select the function
FFT mode
・Select the FFT function.
Frequency range
・This setting determines whether only one channel
(1ch-FFT) or two channels (2ch-FFT) are used for FF
T
processing.
・Setting the Frequency Range.
Sampling point
・Setting the sampling point.
Window
Reference
( FFT mode
)
・Select data to be used for FFT processing.
Preparation
・The window function defines the segment of the input
signal that will be processed.
Format
・Setting the Display Format
FFT Analysis Mode
Analysis Channel
X-Yaxis Displays
Display Scale
Averaging Function
・Select the average count.
Interpolation Function
・Interpolation can be set when set the X-Y graph format.
Print mode
Auto Print Function
・Select whether or not to print out the waveform
automatically after it is captured.
Auto Save Function
・Select whether or not to save the waveform automatically
after it is captured.
Waveform Evaluation
Setting the STATUS1 scree
n
Setting the STATUS1 scree
n
・See Chapter 2.
・Press the STATUS key to call up the
STATUS1 screen.
・See Section 8.3.
・Press the STATUS key to call up the
STATUS2 screen.
・See Section 8.4.
Setting the STATUS1 scree
n
Setting the STATUS1 scree
n
See Section 8.3.1
See Section 8.3.3
See Section 8.3.4
See Section 8.3.5
See Section 8.3.7
See Section 8.3.2
See Section 8.3.6
8.3.8
8.3.9
8.3.10
8.3.11
See Section 8.4.1
See Section 8.4.2
See Section 8.3.3
See Section 8.3.4
See Section 8.3.5
See Section 8.3.6
8
.2 Operation Sequence (FFT)