User Manual

142
────────────────────────────────────────────────────
7.6 Start and Stop Operation (REC&MEM)
────────────────────────────────────────────────────
・See Section 7.3 STATUS settings
・See Chapter 9 Input channel settings
・See Chapter 10 Trigger Functions
・Press the START key and LED light.
・When the trigger mode is set to "TIMER," the system waits until th
e
set time is reached.
・Displays "Storing".
・Waveform appears on the screen and printout starts
(Auto print: ON).
・Using the VIEW key to display the time (from measurement starte
d
time).
・Memory data recording starts when trigger condition are met.
When the pretrigger has been set for the memory waveform and
the trigger conditions are met until the trigger point, the system
initiates data acquisition at that time.
・When Sequential Save is enabled, the memory waveform is store
d
each time a trigger occurs.
・When Auto Save is on, pressing the STOP key during measurement cause
s
measurement data to be saved automatically until the stop.
・End of measurement
・Each time when trigger conditions are met, data are recorded and
memory contents are overwritten.
・When STOP key is pressed, measurement stops after data
corresponding to recording length have been stored in memory.
(auto save are not executed.)
Trigger
condition are
met
Setting to the ８８２６
･STATUS Settings
･Channel Settings
･Trigger Settings
Setting the 8826
･STATUS Settings
･Channel Settings
･Trigger Settings
Measurement Start
Measurement Start
Measurement end
Measurement end
Recording end
Recording end
Trigger mode:SINGLE
Trigger mode:REPEAT
・Autosaving is executed.
RE
C
MEM
Trigger mode:TIMER
・The measurement is repeated at the set time interval until the stop
time is reached.
NOTE
7
.6 Start and Stop Operation (REC&MEM)
・A stored waveform read by the Recorder & Memory function can be
subjected to waveform processing by the Memory function, but doing so
erases the Recorder waveform.
・While a waveform is being stored, the storage conditions of the memory
waveforms are displayed at the lower part of the screen.
「MEMORY WAVE WAIT TRIG」−−− Trigger wait condition
「MEMORY WAVE STORING」−−− Memory waveform is being stored
「MEMORY WAVE STORE END」−−Memory waveform storage is finished
During Sequential Save:
「MEMORY WAVE XXX/000」−−−−Displays the storing block
(XXX is the last block stored, and 000 is the memory segment number)