User Manual

141
────────────────────────────────────────────────────
7.5 Settings on the Display Screen (REC&MEM)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
Upon pressing the "Recorder & Memory"
function key, the display changes where
indicated in the figure, and you can set
the waveform to be displayed.
：Recorder waveform
：Memory waveform
1
Function
MEM,REC,RMS,FFT
REC&MEM (REC)
REC&MEM (MEM)
･Select function.
2
Trigger mode
(REC)
SINGLE,REPEAT,TIMER ･Select trigger mode.
3
Analog trigger
(MEM)
OFF,LEVEL,OUT,IN,CYCLE ･Set the analog trigger.
4
Pre-trigger (MEM
)
0 to 100%, -95% ･Set the pre-trigger.
5
Time Axis Range
20 ms/DIV to 1 h/DIV (REC)
100μs to 5 min/DIV (MEM)
･Set the time 1 scale (1 DIV).
6
Compression
along the time ax
is
×1 to ×1/500 (REC)
×10 to ×1/10000 (MEM)
･By compressing the waveform, an entire
change can be promptly apprehended.
7
Recording
Length
(Capacity：16 M words
)
SELECT：
25 DIV to CONT (REC)
25 DIV to 2000 DIV (MEM)
ARBITRARY：
1 DIV to 1000 DIV (REC)
1 DIV to 2000 DIV (MEM)
･The length of recording for one
measurement operation (the number of
DIV) can be set.
8
Cursor
Measurement
OFF, , , ＋ ･The A/B cursors can be used.
Display size
NORMAL, WIDE ･The screen size can be changed by
pressing the DISP key.
Input channel
settings
・Analog input
・Logic input
・X, Y axis (X-Y format)
･Enables the measurement conditions for
each channel on the display screen to b
e
set or changed.
See Section 9.9.
Input level monitor
function
Press the LEVEL MON. key. ･See Section 11.5.
VIEW function
Press the VIEW key. ･See Section 11.6.
7
.5 Settings on the Display Screen (REC&MEM)
Explains the setting items on the Display screen.
For details on setting, refer to Section 7.3.
When want to use the JOG control, press the VALUE select key.（The selection window
is not displayed.)