User Manual

127
────────────────────────────────────────────────────
7.3 STATUS1 Settings (REC&MEM)
────────────────────────────────────────────────────
7
.3.7 Setting the Print Mode
Screen: STATUS
1
Press the STATUS key to call up the
STATUS1 screen.
Move the flashing cursor to the print mode
item, as shown in the figure on the left.
Use the function keys to select WAVE.
：Measurement data and the result o
f
calculation are printed as a
waveform.
：Measurement data and the result o
f
calculation are printed as numeric
data.
Selection
Selection
Method
Method
When the waveform format is selected,
determine whether to use the smooth
printing or not.
Move the flashing cursor to the
smooth print item.
Use the function keys to make the
selection.
：Normal printing is carried out.
：Smooth printing is enabled.
Selection
Selection
(1) Setting the Printer Format
(2) Setting the Smooth printing
NOTE
Select the format, waveform, or numerical value should be used to output
measured data.
Waveform： The waveform is printed.
Numerical value： The data spacing interval also must be set.
Printing as a waveform
Smooth printing is implemented for waveforms acquired using the memory
recorder function.