User Manual

118
────────────────────────────────────────────────────
7.2 Operation Sequence (REC&MEM)
────────────────────────────────────────────────────
測定の準備を行います
Installation of the Unit
Turn on the power
Connect the inputs
Select the function
Time axis range
・Select the recorder function.
Recording length
・Determine the speed with which the input signal
waveform is captured.
Select the format
Print mode
Additional recording
Printer function
Auto save function
・See Chapter 2.
Preparation
・Press the STATUS key to call up the
STATUS screen.
Display size
・Determine the length of the data sample for a single
measurement.
・Select the format type for the waveform display screen.
・Select the format, waveform, or numerical value should
be used to output measured data.
・The input waveform is continuously printed in real time.
・Select whether or not to save the waveform automatically
after it is captured.
・Select the display size normal or wide.
Setting the STATUS1 scree
n
Setting the STATUS1 scree
n
Display function
・Select the display function for the waveform display
screen.
Real time save function
・Data can be saved to memory in real time, and
afterwards compressed and stored on disk.
See Section 7.3.1
See Section 7.3.2
See Section 7.3.3
See Section 7.3.4
See Section 7.3.5
See Section 7.3.6
See Section 7.3.7
See Section 7.3.8
See Section 7.3.9
See Section 7.3.10
See Section 7.3.11
7
.2 Operation Sequence (REC&MEM)