User Manual

113
────────────────────────────────────────────────────
6.3 STATUS Settings (RMS)
────────────────────────────────────────────────────
Move the flashing cursor to type, and selec
t
the format.
：Data are stored as binary data.
：Data are stored as text data.
Data stored in the text format is
not readable by the 8826.
Selection
Selection
When the data format to be saved is set to
text data, the intermittent setting item is
displayed. Use the function keys or Jog
control to make a setting.
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Selection
Selection
Set the file name. For the input method,
refer to Section 9.8.4.
When using auto-save, a number is
appended to the name you specify as the
file name. This then becomes the file
name. If you start procedures before
specifying a file name, AUTO is
automatically enabled.
・ Do not use the characters and symbols below
in a file name. A file containing any of these
characters/symbols in its file name cannot be
processed under Windows 2000 or XP. Half-
size symbols: +, =, [,]
NOTE
・With auto-save enabled, channel selection is disabled. Data for all channels is
saved.
・For details on file name when auto-saving, see Section 14.7.
・When the recording length is "continuous", data are not stored.
・For details on connected SCSI device, refer to Section 14.4.
・When cursor A and B are enabled, partial saving is executed.
・If additional recording is enabled, only newly acquired waveforms are saved.
Even when A and B cursors appear on the screen, no partial save is performed.
・During automatic storage, if the measurement is interrupted, waveforms taken
prior to the interruption are stored automatically.
・The directory and the number of files that can be stored in the directory are
limited. For details, see Section 14.7.
・When "COMMUNI" (communications) is selected as Media, Storage Method and Type
are not displayed.