User Manual

110

────────────────────────────────────────────────────

6.3 STATUS Settings (RMS)

────────────────────────────────────────────────────

Screen: STATUS

Press the STATUS key to call up the

STATUS screen.

Move the flashing cursor to the

record add item, as shown in the figure on

the left.

Use the function keys to make the

selection.

：Additional recording is disabled.

：Additional recording is enabled.

Selection

Method

NOTE

・Time values output to the printer and displayed on the screen with the

additional recording function enabled are equal to those of the most recently

acquired waveforms. Therefore, when measuring waveforms in a different

time axis range, always take that difference into consideration.

・ When the 2000 (64 M words: 10000) DIV has been reached, old data will be

overwritten. When OFF, previous data will be erased. Set to ON if erasing

is not desired.

・If auto-save is enabled, only newly acquired waveforms are saved. Even

when A and B cursors appear on the screen, no partial save is performed,

because the setting is disabled when the START key is pressed.