User Manual

89
────────────────────────────────────────────────────
5.3 STATUS Settings (REC)
────────────────────────────────────────────────────
5
.3.11 Setting the Interpolation (dot-line, X-Y only)
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the dot-line
item, as shown in the figure on the left.
Use the function keys to make the
selection.
： Linear interpolation is not
performed.
：Linear interpolation is performed.
Selection
Selection
Method
Method
5
.3.12 Setting the Display Clear Function (X-Y only)
Call up the STATUS screen or DISPLAY
screen.
Move the flashing cursor to the
display clear item, as shown in the figure
on the left.
Use the function keys to make the
selection.
：Display clear is disabled.
：Display clear is enabled.
Screen: STATUS
Method
Method
Selection
Selection
・Interpolation can be set when set the X-Y graph format.
・This setting determines whether the input waveform (sampling data) is to
be displayed and printed as a series of dots or a line using linear
interpolation.
・It sets whether clear the waveform or not when pressing the START key to
start measurement and the previous waveform is left.
・If the waveform is not cleared, overlay is performed.