User Manual

86
────────────────────────────────────────────────────
5.3 STATUS Settings (REC)
────────────────────────────────────────────────────
5
.3.9 Setting the Printer Function (Real Time Printing)
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the printer
item, as shown in the figure on the left.
Use the function keys to make the
selection.
：Printing is disabled.
：Printing is enabled.
Selection
Selection
Method
Method
NOTE
Time-axis range Magnification
50 ms/DIV ×1/2
20 ms/DIV ×1/10
The input waveform is continuously printed in real time.
・At a time axis range setting of 200 ms/DIV or faster, the waveform data
will be printed out later. (See section 18.5)
・While the printer always outputs the data at the measurement
magnification in recording mode, the waveform on the screen is reduced in
size at the ratio shown in the table below, depending on the time-axis range.