User Manual

82
────────────────────────────────────────────────────
5.3 STATUS Settings (REC)
────────────────────────────────────────────────────
5
.3.7 Setting the Print Mode
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the print mode
item, as shown in the figure on the left.
Use the function keys to select WAVE.
：Measurement data and the result o
f
calculation are printed as a
waveform.
：Measurement data and the result o
f
calculation are printed as numeric
data.
Selection
Selection
Method
Method
Setting the Printer Format
NOTE
Select the format, waveform, or numerical value should be used to output
measured data.
Waveform： The waveform is printed.
Numerical value： The data spacing interval also must be set.
Printing as a waveform
In the recorder, the trigger mark ( ) is written as the start position mark.
In an additional recording, the trigger mark is displayed in front of the most
recently entered data.