User Manual

79
────────────────────────────────────────────────────
5.3 STATUS Settings (REC)
────────────────────────────────────────────────────
5
.3.5 Setting the Format
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the format
item, as shown in the figure on the left.
Use the function keys to select the display
format.
Set Which graph type to use when display
format has been set to DUAL, QUAD, OCT
or HEX screen display.
Setting the X-Y screen, see Section 5.4.
Press the CHAN key to call up the
CHANNEL1 screen.
Move the flashing cursor to the point in
the figure on the left. The figure shows
the setting for CH1. Setting for CH2 to
CH 32 should be made in the same way.
Use the function keys to select the graph.
：Display the waveform on graph 1.
：Display the waveform on graph 2.
：Display the waveform on graph 3.
Selection
Selection
Method
Method
：Display the waveform on graph 4.
Flashing curso
r
・The style can be set for showing input signals on the screen display and
recording them on the printer.
・The styles single, dual, quad,（DISPLAY screen）, oct・hex（Print only,
Display quad style）X-Y single・X-Y quad (dot) and (line) are available.
・The voltage per division is automatically changed according to the display
format.
■ In the cases of OCT and HEX (printer only), as far as the printer recording
output is concerned, the waveforms for each channel are automatically
distributed on each graph. (For details on logic channels, refer to Section
9.3.8.)