Installation & Assembly
Installation Instruction
start here
Item No:
15030
SAVE THESE INSTRUCTIO
Note: This Luminaire is designed for use with Hinkley approved 12 volt
landscape systems. Connection to other systems may cause premature
failure or non-intended operation.
LUMINAIRE MOUNTING: (for typical ground stake mounting)
1. To prevent electrical shock, disconnect transformer from electrical supply
before installation or service.
2. Run wire from Luminaire through mounting hole in top of ground stake.
3. Attach Luminaire to ground stake by threading to the mounting hole in stake
until it fits snuggly against the bottom of stem.
Place stake in desired position and insert into ground until the flange of stake
is flush with ground.
5. Strip the two wire leads from the Luminaire and connect to the main supply
wire using the provided silicone filled wirenuts.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR
INJURY TO PERSONS, IMPORTANT SAFETY
INSTRUCTIONS.
1. Lamp gets hot quickly! Contact only switch / plug when turning on.
2. Do not touch hot lens, guard or enclosure.
3. Keep lamp away from materials that may burn.
4. Do not operate the luminaire fitting with a missing or damaged shield.
5. Luminaires shall not be installed within 10 feet (3m) of pool, spa or fountain.
Protected by routing in close proximity to the luminaire or fitting, or next to a
building structure such as a house or deck.
The main secondary wire is intended for shallow burial – less than 6 inches
(15.2cm)
- in order to connect to the main low voltage cable.
Have the length cut off so that it is connected to a connector within 6 inches
(15.2cm) from a building structure, a luminaire or fitting.
empezar aquí
Número
tierra)
superior de la estaca de tierra.
brida de estaca quede al ras con el suelo.
spa o fuente.
El principal cable de baja tensión de la luminaria es:
1.
Protegido por la ruta cerca de la luminaria o el accesorio, o al lado
de una estructura de edificio como una casa o una cubierta.
2.
El cable secundario principal está diseñado para enterramiento
superficial: menos de 6 pulgadas (15,2 cm)
- Para conectarse al cable principal de baja tensión.
3. Corte la longitud para que se conecte a un conector dentro de 6 pulgadas
(15,2 cm) de una estructura de edificio, una luminaria o un accesorio.
Instrucciones de Instalacion
:
Le câble principal basse tension du luminaire doit être
commencer ici
Número del
artículo:
del
actculo:
15030
HH
II
NN
KK
LL
EE
YY
HINKLEY 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkley.com
15030
FREEPORT FAMILY
Silicone filled
Wire nut
Fixture Wire
Supply Wire
1
3
2
To attach cage (3) use screws (2) and secure them to
the holes in the top of the fixture top of fixture (1)
Para fijar la jaula (3) use tornillos (2) y fíjelos a los
orificios en la parte superior de la parte superior del
dispositivo (1)
Pour fixer la cage (3), utilisez les vis (2) et fixez-les
aux trous dans le haut du luminaire en haut du
luminaire (1)
FOR WIRING WITH LOW VOLTAGE
LAMPS TO A TRANSFORMER PLEASE
REFER TO I.S. LV – NEXT PAGE
PARA EL CABLEADO CON LUCES DE BAJA
TENSION A UN TRANSFORMADOR,
CONSULTE I.S. LV - SIGUIENTE PÁGINA
POUR LE CÂBLAGE AVEC DES LAMPES
BASSE TENSION À UN TRANSFORMATEUR,
VEUILLEZ VOUS RÉFÉRER À I.S. LV - PAGE
SUIVANTE