Installation & Assembly

Installation Instructions
Family: Atlantis | Item No. 15502
 Start Here
HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 (p)800.446.5539 / (f) 440.653.5555 www.hinkleylighting.com
Top Cover
Glass
Ground
Unpacking
Luminaire Mounting
(typical ground spike monting)
Lamping
1. To prevent electrical shock, disconnect transformer from electrical
supply before installation or service.
2. Run wire from luminaire through mounting hole in the top of the
ground spike.
3. Attach luminaire to ground spike by threading it on to the mounting
hole in spike.
4. Strip the two wire leads from the luminaire and connect to the main
supply wire using the provided wirenuts. Put the silicone glue, also
provided, in the wirenuts to waterproof.
5. Place spike in desired position and insert into ground until the ange
of the spike is ush with the ground.
1. Unpack the bollard from the box.
2. Remove the bottom cover, bollard mount and the threaded tube
assembly from the bottom of the xture.
Note: Wire is to be protected by routing in close proximity to the luminaire or
tting or next to a building structure such as a house or deck. Wiring should
be buried a maximum of 6 inches (15.2 cm) in order to connect to main
supply wire. The main supply wire must have its length cut o within 6 inches
(15.2 cm) from a building structure, a luminaire or tting.
1. Unscrew the four screws from the top cover and remove the cover. Let
the cover hang over the edge of the xture.
2. Insert the glass and glass holders in the xture.
3. Insert bulb into socket
4. Put the top cover back on and tighten the four screws.