Assembly Instructions

1. Shut off electrical current before starting. If the ﬁxture you are replacing is

turned on and off by a wall switch, simply turn the switch off. If not, remove

the appropriate fuse (or open the circut breakers) until the ﬁxture is dead.

• DO NOT restore current - either by fuse, breaker or switch - until the new

ﬁxture is completely wired and in place.

1. Determine the desired height the chandelier will be installed at.

2. The ﬁxture is supplied with a variety of stem lengths. Determine what combination

of stems are needed to achieve desired length - see Drawing 1.

3. Slip stems over wire and thread ﬁrst stem Into coupler (6) on top of chandelier

. Repeat this process until all required stems are threaded together.

4. Slip wire through center of canopy swivel and thread swivel into stem assembly.

start here

1. Thread two long 8-32 (1) screws provided into the mounting strap (2).

Note: the two screws should be threaded into the gull wing shaped part of the

mounting strap with the ﬂat part of the strap facing up. Make sure screws are threaded

into holes that line up with the holes in the canopy (3) - see Drawing 2.

2. Attach mount strap (2) to junction box with two short 8-32 screws (5) not provided.

3. Make wire connections following the instructions on I.S.18 instruction sheet provided.

4. Slip canopy/ﬁxture over screws (1) and secure ﬁxture with ball knobs (4).

Drawing 1 - Fixture Assembly

Drawing 2 - Fixture Assembly

2222

2223

stem

wire

junction box

stem

hanging instructions

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS AND

ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.