Assembly Instructions
assembly instructions
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, determining the length of stem required, mounting
the mounting strap to the junction box, making all necessary electrical connec-
tions, hanging the fixture from the ceiling, and then installing the glass.
* It is recommended that assistance be available when installing this fixture
start here
Drawing 1 - Fixture Assembly
6
5
2
8
7
9
C
D
E
G
F
A
4
3
1
B
10
11
REVISION 2
1. Slip threaded end (B) of upright (2) into recessed hole (A) of canopy (1) - see
Drawing 1.
2. Slip lockwasher (3) onto threaded end (B) of upright (2). Then thread on hex nut (4) -
do not tighten at this time.
3. Re
(1) to the bottom end of the uprights temporarily using knob with stud (11).
peat steps 1 and 2 for remaining uprights. After uprights are in place attach ring
4. Slip cap (5) along wire and place on top of canopy (1).
5. Slip coupler (6) along wire and thread onto threaded tube (C) and tighten.
6. The diffuser (7) is attached by first removing the ball knob studs (8) from the cluster
plate (D).
7. Place diffuser (7) onto top of cluster plate (D) and line up the holes.
8. Thread ball knob studs (7) back into cluster plate (D) to secure diffuser. Repeat with
opposite diffuser panel.
9. Please refer to the hanging instruction sheet
Line up hole (F) in ring upright (G) with hole (E) in end of upright (2).
Slip threaded stud (11) through hole (F) in ring upright (G) and thread into hole (E
)
of
position.
upright (2). Align uprights and then tighten hex nuts (4) to secure uprights in
1. Prior to installing the glass fixture can be lamped accordingly.
2. To install glass, remove two of the knob with studs (11) that attach the ring (10) to the
uprights (2).
3. Now loosen the one remaining knob with stud (11) so the ring (10) is supported at this
point.
4. Carefully tilt ring downward and slip glass (9) into ring.
5. Tilt ring and glass back into position and thread knob and studs removed earlier into
place and tighten to secure glass.
provided to hang this fixture. Then refer
back to this sheet to complete fixture assembly