Instruction Manual

06
|
hinkley.com
INSTALLING THE FAN
Fig. 1
Fig. 2
REMEMBER to turn off the power. Follow the steps below to hang your
fan properly.
Carefully lift fan motor assembly (without the blades) into position by
hanging the motor assembly onto the hook from the ceiling adapter
plate allowing it to hang freely. (Fig. 1)
Fan
Motor
Outlet Box
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the
safety cable from the fan. Loop the safety cable around the
wood screw that was just attached to ceiling joist. Feed the end
of the cable into the clamp and pull as much cable through as
possible. Firmly tighten screw in the clamp. Cut offffexcess cable.
(Fig. 2)
You are now ready to make the electrical connections.
INSTALLATION OF SAFETY CABLE SUPPORT
Safety Cable Clamp
Safety Cable
Wood Ceiling Joist
Safety Cable Loop
Wood Screw
And Washer