Instruction Manual

hinkley.com
6
HANGING THE FAN
Remove hanger ball from downrod by loosening set screw in the side of
the hanger ball. Slide hanger ball down and remove cross pin. (Fig. 1)
Carefully support fan body (motor) in its packing with the mounting collar
(where the wires come out) facing upward.
Loosen the security set screw and remove the downrod pin and cotter pin
from the coupling on top of the motor assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable from the fan
through the downrod. Thread downrod into coupler until holes align. Insert
downrod pin through holes in mounting collar and downrod; clip cotter pin
through small hole in end of downrod pin to hold downrod in place.
Securely tighten set screw against downrod using a large flat-head
screwdriver to ensure a tight fit against downrod. Tighten nuts against
mounting collar.
1
2
3
4
5
Downro
d
Set screw
Cross pin
H
anger ball
WARNING: Make sure the cross pin is installed well on hanger ball with downrod.
Figure 1
Figure 2
Downrod
Downrod pin
Hook-up (5) Wires
Security Screws
Cotter pin
Top of Fan Body
Mounting Collar