Instruction Manual

hinkley.com
12
INSTALLING THE WALL CONTROL
Select a desired location. Use the wall plate to mark the
location of the mounting holes. Plastic wall anchors or
mounting screws are needed for this application. (Fig. 1)
Seat the cradle B into the wall plate. Secure the wall plate to
the wall using the provided hardware.
Snap the face plate cover onto the wall bracket.
Remote transmitter will be held in place with built in magnets.
1
2
3
4
Option 1. Flat Surface Installation
Remove the existing wall plate and the old switch from the wall
outlet box.
Seat the cradle A into the wall plate. (Fig. 2)
Connect the black lead wires from the switch in the cradle A to
the black wires in the switch box. Hot input wire to one of the
cradle A switch leads. Power lead to the fan is connected to
the remaining switch lead.
Connect the wall plate / cradle A assembly to the wall outlet
box using the supplied hardware.
Snap the face plate cover onto the wall bracket.
Remote transmitter will be held in place with built in magnets.
1
2
3
4
Option 2. For Single Gang Box
5
6
HIRO Control System
Transmitter
Face plate
Wall plate
Cradle B
Wall
Plastic
anchor
Outlet box
Transmitter
Face plate
Wall plate
Cradle A
Figure 1 Figure 2
REMEMBER to turn off the power before you begin.
NOTE: 1. Control must be installed within 30 feet of fan.
2. Secures to any surface or application: flat wall, single
gang box, multi gang box.