Installation Sheet

assembly instructions

Family: Hadley Item No. 3304

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

1. Prior to installing glass, ﬁxture should be lamped.

2. To install glass (2), lay glass into ring (3) - see Drawing 2.

3. Slip the 3 holes (J) of ring (3) over the threaded studs (I) of the uprights (UP) and hold

in position.

4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting strap to the junction box, making all necessary electrical connections,

hanging the ﬁxture from the ceiling, and then installing the glass.

start here

3304

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Mounting

Drawing 2 - Glass Installation

01.01.13

H I N K L E Y L I G H T I N G 33000 P i n Oak Pa r k way Avon L ake, OH 4 4012 8 0 0.446.55 3 9 / 440.6 5 3 .5500 hinkleyl i ghting.c o m

1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting

plate (B) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (C)

in the canopy (1).

2. Attach mounting plate (B) to junction box (J), using screws (G) not provided & slip

supply wires through large center hole.

1. Hang the ﬁxture by slipping the mounting holes (D) in the canopy (1) over screws (B),

mounted in strap (A) previously - see Drawing 2.

2. Thread ball knobs (E) onto end of screw (B) and tighten to secrure ﬁxture.

T24 JA8-2016

PAGE 1
3304 assembly instructions Family: Hadley Item No. 3304 T24 JA8-2016 Drawing 1 - Fixture Mounting s tart he re J 1. Find a clear area in which you can work. 2. Unpack fixture and glass from carton. B 3. Carefully review instructions prior to assembly. A D *** The construction of this fixture will be accomplished by first mounting the mounting strap to the junction box, making all necessary electrical connections, hanging the fixture from the ceiling, and then installing the glass. G 1.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount wiring instructions supply wire A C Indoor Fixtures E 1.