Installation Sheet

I.S. 18 wiring grounding instructions
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
wiring instructions
Indoor Fixtures
grounding instructions
Drawing 1 - Flush Mount
Drawing 2 - Chain Hung
supply wire
fixture leads
twist-on
connectors
Drawing 3 - Post-Mount
twist-on
connectors
1
A CC
B
D
supply wire
fixture leads
A C
B
D
1
2
supply wire
fixture leads
A C
B
D
twist-on
connectors
E
2
E
E
E
E
E
E
I.S. 18
L I G H T I N G
HINKLEYHINKLEY
1. Connect positive supply wire (A) (typically black or the smooth, unmarked side of the
two-conductor cord) to positive fixture lead (B) with appropriately sized twist on connector -
see Drawings 1 or 2.
2. Connect negative supply wire (C) (typically white or the ribbed, marked side of the
two-conductor cord) to negative fixture lead (D).
3. Please refer to the grounding instructions below to complete all electrical connections.
Outdoor Fixtures
1. Connect positive supply wire (A) (typically black or the smooth unmarked side of the
two-conductor cord) to positive fixture lead (B) with appropriately sized twist on connector -
see Drawings 2 or 3.
2. Connect negative supply wire (C) (typically white or the ribbed, marked side of the
two-conductor cord) to negative fixture lead (D).
3. Cover open end of connectors with silicone sealant to form a watertight seal.• If installing a
wall mount fixture, use caulk to seal gaps between the fixture mounting plate (backplate)
and the wall. This will help prevent water from entering the outlet box. If the wall surface is
lap siding, use caulk and a fixture mounting platform specially.
4. Please refer to the grounding instructions below to complete all electrical connections.
Flush Mount Fixtures
For positive grounding in a 3-wire electrical system, fasten the fixture ground wire (E) (typically
copper or green plastic coated) to the fixture mounting strap (1) with the ground screw (2) -
see Drawing 1. Note: On straps for screw supported fixtures, first install the two mounting
screws in strap. Any remaining tapped hole may be used for the ground screw.
Chain Hung Fixtures
Loop fixture ground wire (E) (typically copper or green plastic coated) under the head of the
ground screw (2) on fixture mounting strap (1) and connect to the loose end of the fixture
ground wire directly to the ground wire of the building system with appropriately sized
twist-on connectors - see Drawing 2.
Post-Mount Fixtures
Connect fixture ground wire (E) (typically copper or green plastic coated) to power supply
ground with appropriately sized twist-on connector inside post. Cover open end of connector
with silicone sealant to form a watertight seal - see Drawing 3.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com