Installation Sheet

assembly instructions

Item No. 3301

1. Find a clear area in which you can work.

3. Carefully review instructions prior to assembly.

1. Prepare gem strap (A) for mounting by threading two screws (B) provided into back of gull

wing bracket of gem strap (A) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)

in the ceiling pan (1) - see Drawings 1 and 2.

2. Mount gem strap (A) to junction box (J), using the two 1” screws (C) not provided.

(I.S.

18) and follow all instructions to make all necessary wiring connections. Then refer back to this

1. (D) in the ceiling pan (1) over the screws (B) in the

mounting strap (A) - see Drawing 2.

2. Thread on ball knobs (F)

2. To install glass (2), lay glass into ring (3).

3. Slip the 3 holes (H) of ring over the threaded studs (G) of the uprights (UP) and hold in position.

4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.

5. Fixture is complete and power can be restored.

mounting strap to the junction box, making all necessary electrical connections, hanging

start here

3301

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 2 - Fixture Mounting

Drawing 3 - Glass Installation

Drawing 1 - Strap Detail

(side view)

gull wing

bracket

01.01.12

L I G H T I N G

HINKLEYHINKLEY

T24 JA8-2016

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

PAGE 1
L I G H T I N 3301 HINKLEY assembly instructions G Item No. 3301 T24 JA8-2016 s tar t h ere Drawing 1 -Strap Detail B B 1. Find a clear rea a in whichyou canwork. gull wing bracket 2. (side view) Drawing 2 -Fixture Mounting 3. Carefullyreview instru ctions prior to assembly. mounting strap to the jun ction box, making all ne cessary electrical connections, hanging J A B C 1.
PAGE 2
L I G H T I N I.S. 18 wiring grounding instructions G I.S. 18 HINKLEY SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount wiring instructions supply wire A C Indoor Fixtures E 1 2 twist-on connectors D B fixture leads 1.