Use and Care Manual

STEP 1: _________________________________________________________________________________________
Insert ¼” X 2” Bolt (E) through the Glider Bearing Strap (H) and Repeat the process of correctly installing the Glider Strap Bearing (H)
into the pre-drilled holes in the to of Glider Base as shown below. to the remaining three corners of the Glider Base. Once all are installed
Pace the nut provided on the ¼” x 2” bolt and hand tighten. Fig. 5 go back and retighten with wrenches. Fig. 6
Be sure that the Glider Strap Bearing (H) flares out toward the bottom.
It is possible to install the bearing backwards. Fig. 5
Fig. 5 Fig. 6
STEP: 2____________________________________________________ _____________ _______________________
Lay Glider Back (A) flat on the box and place Glider Side (C-L) along side Lay the Glider Seat (J) under the Glider Back (A) and next to the Glider
the back. Align the pre-drilled holes in the Glider Side (C-L) with the Side (C-L). Note: the seat is marked front and back in the front and back
holes in the Glider Back (A). Place Hex Head Bolt (F) into pre-drilled hole of the seat. It is possible to install the seat backwards. Fig. 8
and hand tighten with Hex Wrench provided. Repeat for the upper bolt. Fig. 7
Fig. 7 Fig. 8
4