User's Manual

深圳星脉医疗仪器有限公司

* In case of equipment failure, the error code will be displayed in the format of "EC XX", see

the section on Common Failures for details.

* State that the blood pressure measured should be explained by a professional.

The product is not intended for newborns.

*The specifications and labels of this product meet the requirements of EN1060-1 and

EN1060-3

*Frequent inflating can lead to blood clots and discomfort

*Too Frequent measurements may result poor circulation or bruising

*Do not put the cuff over a wound, and it will cause further injury

*If there are arterial or venous shunt tubes on the arm, please follow the doctor's instructions

before use, otherwise it may cause physical discomfort

*People who have had mastectomies may be unwell or have mis-measured results

*Do not use other medical electrical equipment on the blood pressure measuring arm

*Please confirm (for example, by observation of the relevant limb) whether this product is

available No lasting damage to the patient's blood circulation.Suffering from blood

circulation disorder,For patients with blood diseases, please use under the guidance of a

doctor.Acute internal bleeding may result from compression of the arm during measurement.

*While in use with a patient,Do not service and maintain the device.

* The device compliance with IEC 60601-1-2,keep away other HF device.

*Please assure that connect The part’s voltage of input or output compliance with

IEC60601-1 the requirement of safe extra low voltage,and the part of input or output forbid

connecting other device.

* The manufacturer responsible for After service ,the people with unauthorized do not

repair calibration the device.

*the time from switching “ON” until the device is ready for NORMAL USE ,That time less

10s.

*when the ambient temperature is 20 °C ,the time that the device to warm from the

minimum storage temperature between uses until the device is ready for its intend use need

one hour;

*when the ambient temperature is 20 °C,the time that the device to cool from the maximum

storage temperature between uses until the device is ready for its intend use need one hour