User's Manual

深圳星脉医疗仪器有限公司

(1)press the "start/stop" button,the cuff start to inflate automatically,increasing number on the

display ,remain still and do not move your arm and until the measurement process is

complete.

(2) When the measurement is complete,your cuff completely defeat, your blood pressure and

pulse rate are displayed and broadcast.

4.3Taking a measurement by the App (Apply to Q06B)

(1)Login the APP,press the "start/stop" button on the Main page,,the cuff start to inflate

automatically,increasing number on the display and APP ,remain still and do not move your

arm and until the measurement process is complete.

(2)When the measurement is complete,your cuff completely defeat, your blood pressure and

pulse rate are broadcast and displayed on the device and the APP .

Notice: To stop the inflation or measurement push the Start/Stop button,the monitor will stop

inflating and start deflating ,and will turn off .

5.Error message

When an error occurs, the screen will display the following error code:

Error code

Cause

Remedy

EC01

Cuff not applied correctly

Remove the cuff ,read “taking a measurement”

Wait 2-3minutes

Take another measurement

EC04

Weak signals, which can be measured when

the pulse is too weak or when the cuff is too

loose

Make sure that the measured part is in good

contact with the cuff and that the arm

circumference is within the measured range

EC06

Excessive motion may be measured when

the signal contains motion spurious or too

much interference

Pay attention to avoid talking, fidgeting and

measuring again during measurement

EC07

Overpressure was measured, with cuff

pressure exceeding 290mmHg in adult

mode

Wait 2-3minutes

Take another measurement